Pentair IntelliPro VS-3050 Bedienungsanleitung

IntelliPro™ VS-3050 Variable Speed Swimming Pool PumpQuick-Start GuideStep-by-step instructions for easy set-up and operation

Turn the pump clamp and lid in a counterclockwise direction until they stop, and remove.Fill the pump strainer pot with water.Reinstall the pump clamp

Priming the IntelliPro VS-30509Ensure that the pump is powered on and the green power LED light is on.Press the Start button to start the pump.Press t

You can change these presets in 10 or 20 RPM increments.Each setting can be adjusted to run at speeds between 400 RPM and 3450 RPM. Typically the lowe

Obtaining the ideal  ow for a given application is an audio-visual feedback process, and may require some trial and error. When you have eliminated c

Warnings and Alarms If an alarm condition occurs, the pump will stop running and the red LED will  ash continuously to indicate the presence of

For more detailed instructions on IntelliPro™ VS-3050 installation, operation, and troubleshooting, refer to the IntelliPro VS-3050 Installation and U

PAGE 1 Before You Get Started 2 The Performance Secret 4 Safety Warnings 5 Wiring/Plumbing 6 Control Panel 7 Stand-Alone Set-Up 8 Priming 9 S

Before you get started...You’re about to discover just how simple it is to program the IntelliPro VS-3050 Variable Speed Pump. Within minutes, the Int

IntelliPro™ VS-3050 Quick-Start Guide2

How is this incredible performance possible? The IntelliPro VS-3050 is the first pump to use a permanent magnet synchronous motor (PMSM). But the rea

4WarningsBefore you begin programming, please read the important safety warnings below.• Never go inside the drive enclosure. The capacitor bank hold

Important Safety Warnings5WiringThe IntelliPro VS-3050 should be wired line side, i.e. directly to a 220V to 240V circuit breaker with a minimum 20 am

Control Panel 1236Speed 1, speed 2, speed 3, and speed 4 button/LED: Press one of the speed buttons to select the desired preset pump speed. The pump

Operator Control PanelStand-Alone Set-Up (no controller or appliance communicating with IntelliPro VS-3050)The IntelliPro VS-3050 must be primed befor