Pentair EasyTouch Pool/Spa Control System LX-100EZ Bedienungsanleitung PDF herunterladen (Seite 17)

Rev. F 3-26-04 17 P/N 520050

WATER TEMPERATURE SENSOR

For use with optional Indoor Control Panel only.

Select a convenient location to mount the Temperature Sensor (model TS-5L) in the plumbing system between

the filter pump and the heater.

Drill a 5/16” diameter hole in the pipe, and insert the Sensor.

Use a screwdriver to open the hose clamp (included). Position clamp over the Sensor, and gently tighten around

the pipe.

CAUTION

Overtightening of clamp can cause deformation of o-ring seal.

Run 2-conductor cable (25 ft. is included with Installation Hardware package) between Sensor location and

low-voltage compartment of LX-100 RF Power/Load Center.

At the LX-100 RF Power/Load Center, strip insulation of both conductors ¼”, and connect to circuit board at

SNS- and SNS+ Screw Terminals. Pay attention color-coding (green conductor connects to SNS-; red conductor

connects to SNS+).

+12

FRZ

AUX1

SPA

GND

SNS+

AUX3

AUX2

SNS-

REMOTE SWITCHES

GHTR

WATER TEMPERATURE

SENSOR

LX-100 RF POWER/LOAD CENTER

RED

GRN

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Keine Kommentare

Pentair EasyTouch Pool/Spa Control System LX-100EZ Bedienungsanleitung Seite 17