Pentair INTELLIFLO VS-3050 Bedienungsanleitung PDF herunterladen (Seite 20)

IntelliFlo VS-3050 Installation and User’s Guide

6. Strip back the cable conductors ¼”. Insert the wires into the either of the COM PORTS

(J7 andJ8) screw terminals located on the left side of the Personality board. Secure the wires with

the screws. For wiring details, refer to ”Pin Configuration” shown below. Note: Multiple wires may

be inserted into a single screw terminal. Strip back the cable conductors ¼ inch. Insert the two

wires into the screw terminals on the board. Secure the wires with the screws.

Pin Configuration IntelliFlo to IntelliTouch pin configuration:

• IntelliFlo: Connect pin 6 (green) to IntelliTouch screw terminal pin 2 (green)

• IntelliFlo: Connect pin 7 (yellow) to IntelliTouch screw terminal pin 3 (yellow)

7. Close the control panel into its original position and secure it with the two access screws.

8. Install the high voltage cover panel and secure it with the two retaining screws.

9. Close the load center front door. Fasten the two spring latches.

10. Switch the power on to the load center.

BLK

GRN

YEL

RED

Pin configuration

IntelliTouch COM port (J7/J8)

screw terminal

hcuoTilletnI

lanimretwercs

rotcennoc

olFilletnI

)elbaceriw-2(

)NRG(2)6niP(NEERG

)LEY(3)7niP(OLLEY

Pin 6

(Green)

Pin 7 (Yellow)

IntelliFlo connector pin configuration

IntelliTouch Personality

board COM PORT

(J7/J8)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Keine Kommentare

Pentair INTELLIFLO VS-3050 Bedienungsanleitung Seite 20